GPF Opening a Project in 6.0.0.2

[arpipeline]

OS = 98SE

I just installed the 6.0.0.2 update and began rebuilding my projects -- there are three. I opened the first project, which contains about 100 files and rebuilt it with no problems. I then selected File/Open and browsed to the next project (512 files), double clicked and the following GPF occurred (I was able to open and succesfully build the project after restarting SF):

SUF60DESIGN caused an invalid page fault in
module SUF60DESIGN.EXE at 025f:00477f27.
Registers:
EAX=37cbc3c0 CS=025f EIP=00477f27 EFLGS=00010206
EBX=0057b4b0 SS=0267 ESP=0082e678 EBP=0082e6a4
ECX=0058cb38 DS=0267 ESI=37cbc3c0 FS=7d2f
EDX=0053d4e4 ES=0267 EDI=0082ecf0 GS=0000
Bytes at CS:EIP:
8b 36 83 c0 08 8d 4d f0 50 e8 fa b4 07 00 53 8d
Stack dump:
00c72430 0053d690 00000001 06df76f8 76b80567 030020e7 20e77628 00589354 0082e7b0 00523fa8 00000001 0082e6bc 004f7699 00589354 0082e854 0053d690

[Mark]

Re: GPF Opening a Project in 6.0.0.2

Hi,

I have tried to recreate this, but I have been unable. Has it happened to you again? Or does this seem to be an isolated incident?

Do you know if the projects were converted from 5.0? Or do you know which version of Setup Factory 6.0 they were originally created with?

mark.

[arpipeline]

Re: GPF Opening a Project in 6.0.0.2

Mark,

I was a converted project from 5.0 that was built and saved with 6.0.0.1 *before* I installed the 6.0.0.2 patch. It seems to be an isolated incident. It has not happened again. I just wanted to post the error code to see if it meant anything to you.

Andy

[Mark]

Re: GPF Opening a Project in 6.0.0.2

Hi,

Thanks for the post; we appreciate all posts like that, even if they turn out to be isolated incidents.

If anything else comes up be sure to post it.

mark.