Tweet
I have a project where I have added the VB6SP5 and MSJET40SP3 runtimes as downloaded from IndigoRose and the relevant files from MSFT. The set-up builds fine.
When running the SETUP I notice that MDAC and JET runtimes appear to install twice. For example, MDAC is copied to \WINDOWS\TEMP, then a few more of my own files, then MDAC is copied again. This occurs with the JET40REBOOT as well. When MDAC has installed itself, I see the same reboot screen twice telling me that MDAC 2.6 requires to reboot. MDAC is NOT included in my main project - only via the runtime support module.
The system I am installing to is a clean Win98SE install (from a Ghost image) and nothing else pre-installed other than the modules in Win98SE. Reading the JET40SP3.SF6 file I can't see how this should be but it does.
LATER. Checked out the install log and sure enough, it does copy MDAC and JET40REBOOT twice which presumably means was compressed into the SETUP twice. If you want I can email you the install log and the .SF6 file I use.
[This message has been edited by JXBURNS (edited 12-20-2001).]
When running the SETUP I notice that MDAC and JET runtimes appear to install twice. For example, MDAC is copied to \WINDOWS\TEMP, then a few more of my own files, then MDAC is copied again. This occurs with the JET40REBOOT as well. When MDAC has installed itself, I see the same reboot screen twice telling me that MDAC 2.6 requires to reboot. MDAC is NOT included in my main project - only via the runtime support module.
The system I am installing to is a clean Win98SE install (from a Ghost image) and nothing else pre-installed other than the modules in Win98SE. Reading the JET40SP3.SF6 file I can't see how this should be but it does.
LATER. Checked out the install log and sure enough, it does copy MDAC and JET40REBOOT twice which presumably means was compressed into the SETUP twice. If you want I can email you the install log and the .SF6 file I use.
[This message has been edited by JXBURNS (edited 12-20-2001).]
Comment